Water leaks can occur because when you replace a automobile windshield chip repair, the factory seal is broken. This seal was created in a climate controlled environment and is designed to provide support for both the roof as well as helps to ensure that airbags properly deploy.
I have seen this procedure first hand and walked away shaking my head wondering why anyone would want to do this to their windshield. Plus, if you haven't had a new windshield in a while it becomes pitted and is very difficult to see in the sun light or at night. If you have picked up a crack, more than likely it's been hit many times already and is probably pitted.
Replacing a car's windshield can be quite a costly affair. An alternative could be to try to repair your windshield, although this will only be feasible for smaller cracks. For any large cracks, you'll have to replace your windshield. There is however a number of steps you could take to ensure that you find a good and cheap automobile windshield chip repair deal.
If you have insurance that will cover windshield repair with a low deductible, this may be a good option. Many companies that specialize in windshield repair will pay the deductible for you provided it's under $100. If you call ahead to make an appointment most of these companies can replace the windshield in less than an hour. If you don't make an appointment, you may have to wait a few hours if there are many customers in front of you.
If the crack looks exactly the same when completed, it's very likely the technician didn't inject the resin properly. A properly completed repair with cause each area of the damage to disappear from at least from one angle of vision (ex: looking from one side, looking from below, looking from above, etc.).
Thread the repair tube into the suction cup tool since the suction cup is directly over the damaged area. You may need to screw it tightly but don't use any tools, just your hands. The proper alignments of the tools are very essential in repairing windshield, which is why you have to check from inside the car if the rubber is directly on the top of the damage area. Now you have to open up the supper tube and add it to the repair tube. Add drops of repair resin and then put a film underneath the resin and let it dry for ten minutes.